Tag Archives: splicing

Why new Splices fail – Splice Failures resulting from Rubber Compound Incompatibility

An ailing economy has forced users of conveyor belting to find ways in which to extend the life of the belt. This can be achieved, but only if the conveyor system is well maintained and operated within original design parameters. In the recent past, a significantly aged belt was replaced by a new belt, thus virtually eliminating the risk of failure. Now, however, taking into account the cost of belting and the lack of capital in many companies, every last bit of life is squeezed out of a belt. Due to these factors it has become quite a common practice to replace only severely damaged portions of belt. Continue reading Why new Splices fail – Splice Failures resulting from Rubber Compound Incompatibility

Flexco TUG HD Belt Clamp simplifies Maintenance Work on Conveyor Belts

Rosenfeld, Germany – When a conveyor belt is stopped for maintenance, say in a coal mine, its own weight can create problems by distributing the tension unevenly. To ensure that a belt can be safely cut and securely spliced by service technicians, the forces in the area under repair should be spread over the whole width. For this purpose Flexco has developed the TUG HD belt clamp. It is suitable for a variety of materials and belt types – and meets rigorous industry standards. Continue reading Flexco TUG HD Belt Clamp simplifies Maintenance Work on Conveyor Belts